Varley Lithium Li5 Battery
May 9, 2016
AIM G Dash
May 19, 2016
Show all

AIM MXS – MXG

£1,500.00 + VAT


Description

AIM MXS – MXG

MXS and MXG are the new AiM dashloggers designed to acquire and display data coming from your ECU, the internal accelerometer and gyro, as well as from the GPS Module included in the kit, analog/digital inputs and predefined math channels.
Performance and data acquired can also be incremented adding up to eight expansion modules.
The only difference between the MXS and MXG is size: a compact 5″ display for MXS, a 7″ display for MXG, better fit for wide cockpit installations.

A high contrast TFT display identifies MXS/MXG at the first glance.
An ambient light sensor keeps the backlight at optimum brightness levels.

You can define all the custom pages you wish, choosing among a wide library of page styles, defining which data to be shown, their end of scale and measure units.
Swapping between pages can be managed pushing one or two pushbuttons.

MXS/MXG feature configurable RGB alarm LEDs: you choose the conditions, you choose the colors.
Select a solid alarm or flashing one – and the flashing frequency, choose to have an accompanying text message, and set the alarm priorities.

Six configurable RGB alarm LEDs for MXS

Eight configurable RGB alarm LEDs for MXG

MXS/MXG feature two digital outputs.
Each of them can give an output of 1 amp at 12 volts: they can be configured in order to be turned on/off depending on the value of the analog or digital inputs.
They permit to automatically run external systems, i.e. to switch on/off additional lights, to activate/de-activate a cooling fan or circulation pumps, etc. when a certain event happens.

Choose from a host of advanced multicoloured RGB shift light patterns that can be customized to your liking, and for each unique gear when required.

Using the built-in CAN bus, you can add expansion modules to the MXS/MXG to increment the performance and the data acquired:

GPS Module
Thanks to GPS05 Module (included in the kit) and its GPS Manager software, you can immediately get laptimes and all data needed for engine tuning as well as for improving driving technique.

Channel Expansion
It permits to add 4 0-5Volt analog channels for pressure, temperature sensors and potentiometers. Two of these channels can be configured to receive digital inputs like wheel speed.

TC Hub
It adds 4 K thermocouples.

LCU-One Lambda Controller
Wide band Lambda controller LCU-One, with Bosch LSU 4.9 probe, providing all Air/Fuel data, lambda value and exhaust gas temperature, allows to perfectly tune the carburetion.

SmartyCam HD cameras
The on-board cameras that overlays on videos the data sampled by your logger.

Firmware under development:
Memory Module
Thanks to the SD Card, Memory Module can record all your data in a file that can be downloaded on your PC for post-analysis. Memory Module, with 16Gb capability, can be connected via CAN-Bus to MXS/MXG and to all AiM loggers.